How to Build a Retractable Canopy

source : cdn.gardenista.com

Building a retractable canopy is not a difficult thing, you can also do it yourself at home. Here GO HOUSE will share tips with you blogger friends. Let's look at this article

before you do that there are some tools and materials that you need to prepare.

Equipment:
-Drill
-Set detailed right
- Sewing Machine (optional)
-Wood Stencils
-Measuring tool
-Stairs
-Hammer

Material

- Fabric canopy
-Cedar board
- 1/8-inch thick stainless steel wire mesh
-2 1/2-inch screws
- Nylon rope, 1/8-inch diameter
-Lime tailor (optional)


Instruction

Choose Canopy Cloth
The best canopy fabric for your pergola will vary depending on a number of factors, including the weather in your area and your shade preferences.
Fabric for sails: 100% water resistant, durable and attractive in acrylic or ripstop nylon Fabric for sails is the preferred choice for canola do-it-yourselfers. Look for a 6 foot wide cloth.

The size of the fabric canopy

When fully extended, the canopy must be the size of a pergola area, plus at least 20% more to account for the curtains. Heavier fabrics like the screens will fold; muslin and linen will be reduced. Determine how much you want to achieve when the canopy is extended. The narrower fabrics have a clean and refined appearance. The fabric with a deeper bend makes your pergola spacious and fantastic. Find the area of ​​your arbor by multiplying its length by its width.

Canopy sewing fabric (optional)

Since the fabric of the canopy rarely has a width that corresponds to the width of the arbor, you decide if you want to sew separate pieces of the canopy or leave them separated. For example, a 12 foot wide pergola will require two pieces of fabric, each 6 feet wide. Use a sewing machine to sew both lines of the canopy fabric. The gauze is too thick to sew by hand, but muslin and linen can be sewn manually. Many do-it-yourselfers prefer the appearance of separate canopy strips.

Cut the canopy support bar

The canopy support slats will be fixed to the top of the canopy with staples and the slats will slide along the wire rope on the eye screw. With an electric saw, cut the board to half the width of the canopy. In general, plan on a board for every 18 inches of canopy length, even if there is room at your discretion. The increase in the number of boards creates a serrated and lined appearance. A smaller number of panels produces larger and lower blinds.

Keep support bar (optional)

Cedar wood naturally produces a silver gray color and the oil remains protected for many years. But if you want to add protection or a different look, you can choose to treat the cedar boards with semi-transparent or solid colors.

Attach the support bar to the canopy

Stretch the canopy on a clean surface. Using a tape measure and a tailor's or carpenter's pencil, lightly mark the position of the support slats along the sides of the canopy. In order for the canopy to run properly, the support beams must be parallel to each other and all the rods must be perpendicular to the side of the canopy. The support plates must also be positioned at each end of the canopy. At each pair of marks, slide the support bar under the canopy and pinch the canopy onto the bar.

0 Response to "How to Build a Retractable Canopy"

Post a Comment

Note: Only a member of this blog may post a comment.

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel